![]() This will loosen the nozzle and allow you to unscrew it by hand. Use the hammer to gently tap on the end of the nozzle. Now that the O-ring is removed, you can begin to disassemble the torch. With the packing nut removed, the O-ring should come out easily. This is the nut that holds the O-ring in place. Next, use the screwdriver to unscrew the packing nut. With the handle removed, you will be able to see the inner workings of the torch. Start by unscrewing the two small screws that hold the handle in place. If you do not have a new O-ring, you can purchase one at your local hardware store. You will also need a new O-ring and some fresh white grease. A small screwdriver, a hammer, and a pair of pliers will do the trick. With a few simple tools, you can have your torch apart in no time. Whether you need to replace a part, fix a problem, or clean it, taking your torch apart is not difficult. This lets the gasses stabilize and gets rid of any unnecessary vapors.Assuming you would like an essay discussing how to take apart a torch: There are many reasons you may need to take apart your scorch torch. Wait 10 minutes before using your lighter.Make sure your butane can nozzle is seated correctly into the filling valve. Hold the lighter back up and place your butane fuel nozzle into the refill valve.use a small long rod and hold it for 10 seconds. Hold your cigar lighter with the refill valve up.Non-disposable cigar lighters will need to be refilled every time the butane gas gets low. Learning how to refill your cigar lighter is very important. Make sure that the device is turned off after each use. ![]()
0 Comments
Leave a Reply. |